Gpad Gforce dont Boot up after flashing with MfGTools

[Semtex]

Hi,

I try flash an new firmware with MFGtools, all is fine, says MfGtool.

Before I flash I work with Android 2.3 but there`s no WIFI,
so I want to downgrade to Android 2.2.
Downgrade via extern SD-Card not work, so I try the MfGTool.

I reset the Pad after flashing, but the Gpad don`t boot up.
Try all functions with the buttons, bootmenue, reset.
Battery was half full.
No reaction at all.

Think I must open the pad and setup an new firmware on the internal SD-Card?
How can I flash the firmware at the inside SD-Card?
Is there any download possible for that?
Can I configure the bootloader new?
Why the bootloader don`t Boot up?
Any suggestions, any help?

Regards

Semtex

[willPanda]

Sorry to hear that. is your tablet the Gforce with Bluetooth? The android 2.3 firmware our member uploaded to the forum is for his gforce with Bluetooth. We are not sure it can work on other version of Gforce. The Gpad company engineers have been testing it on all version of Gforce now. I will feedback your problem to them. Hope they can offer a solution.

[Semtex]

Hi,
yes it is a bluetooth Version.

I have now long..... press butteon power on and the Level down button.
Now I have connect to MfgTool but got a error by flashing.

Update Error 0xffff0000 (-65536)-

Try very often, but I get every time the same error. I read here that the internal card SD is defect?
Hope not.


Regards

Semtex

[Semtex]

Hi,

my pad lives again, I am very happy!

I take this:
http://www.slatedroid.com/topic/19536-ht-pad-1051-tianfeng-tablet-firmware-upgrade-guide/page__p__199514__hl__herotab__fromsearch__1

Install with MfGtool all is nice, but the same - WIFI not works.
So I install another Firmware now its fine - with the extern SD-Card.

Regards

Semtex

[willPanda]

Glad for you. Thank you for feedback.

[dayanlab]

please let me know which firmware you installedand where to find?

Hi,

my pad lives again, I am very happy!

I take this:
http://www.slatedroid.com/topic/19536-ht-pad-1051-tianfeng-tablet-firmware-upgrade-guide/page__p__199514__hl__herotab__fromsearch__1

Install with MfGtool all is nice, but the same - WIFI not works.
So I install another Firmware now its fine - with the extern SD-Card.

Regards

Semtex

[pim_nl]

You can find the Firmware here:

http://www.mediafire.com/?oadd3hlc5u5vy

Just make sure you use the right version (4GB, 8GB or 16 GB, think the 8GB will do for you)

Next follow all steps as described in the post

Good luck !

[willPanda]

thank you for help, pim.