Welcome to the Pandawill Forum | Community for China Products Discussion.
Page 1 of 2 12 LastLast
Results 1 to 10 of 19
  1. #1
    Administrator
    Join Date
    May 2010
    Location
    Shenzhen, China
    Posts
    6,714
    Blog Entries
    31

    firmware of eken M007

    firmware for eken m007.rar
    This firmware is for eken m007. Here is its link at pandawill.com
    http://www.pandawill.com/eken-m007-m...ld_p40207.html

    Instruction for how to flash Eken M007 with this firmware:
    Note: you'd better to format ur TF card firstly or the device possibly is not able to recognize the card.
    1. unzip this attachment and copy it to ur TF card.
    2. plug ur TF card into Eken M007.
    3. press the power button and the device will identify the firmware and begin to flash automatically.
    4. after finished, start the device again.
    5. done

  2. #2
    I have an error "Format kernel partition Fail! Exit!", when flash this firmware...
    Can you help me? Now my device doesn't boot.

  3. #3
    Hi Vovich1976, may i know your order number, please?

  4. #4
    My order number is 20180899

  5. #5
    Hi, the firmware isn't wrong, please format your TF card and have a try again.

  6. #6
    The report says: Not find UDisk ( /dev/sda )
    Fail to update filesystem/ Exit!
    Is there a firmware version that is installed on the inner Nand drive and not on Udisk?

  7. #7
    Reply 6# [i]leovic
    sorry for all the troubles, would you pls try to use a high quality TF card? let the M007 firmware completely into the TF card, insert the M007 and turn on , then the program will be runs itself, at last it will be remind you ,finished to reflash,then pull out the TF card ,Auto-boot to complete. pls try , good luck

  8. #8
    Used for firmware 2GB SD card and have followed all the recommendations. In addition, established a working firmware!, but for a 7 "tablet. EKEN M007 firmware, I found only on your site (not even on the site EKEN)
    I found on the Internet that some tablets as a flash is used usb flash, which is soldered to the connector usb main board (there are photos). I took off the lid and found the flash, soldered on the processor board.
    What do I do next? Try to solder usb flash?

  9. #9
    Post Last Edit by leovic at 2011-4-10 13:08

    Used for firmware 2GB SD card and have followed all the recommendations. In addition, established a working firmware!, but for a 7 "tablet. EKEN M007 firmware, I found only on your site (not even on the site EKEN)
    I found on the Internet that some tablets as a flash is used usb flash, which is soldered to the connector usb main board (there are photos). I took off the lid and found the flash, soldered on the processor board.
    What do I do next? Try to solder usb flash?

  10. #10
    Post Last Edit by SADBOY at 2011-9-12 16:11

    Prepare update files...
    Update filesystem Start ......

    -->Not find UDisk ( /dev/sda )

    Fail to update filesystem/ Exit!

    Pls help!!


 
Page 1 of 2 12 LastLast

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •